На головну

LIGHTING SYSTEM ELEC

  1. A Radio Communication System
  2. A SYSTEM OF POWER
  3. AIR BLEEDING (HYDRAULIC BRAKE SYSTEM)
  4. Amadeus Information System (AIS)
  5. An 1864 law overhauled Russia's judicial system, making the judiciary an independent branch of government for the first time.
  6. Ass. prof. Zhauticova S. B., Maxutova A. K."Pathophysiology of cardio-vascular system"// Educational-methodical manual// Karaganda, 2006.- 57.
  7. AUTO CHOKE AND CARBURETTOR HEATER SYSTEM

TROUBLESHOOTING +


IF THE HEADLIGHT, HIGH BEAM, INDICATOR LIGHT, TAILLIGHT, MARKER LIGHT AND/OR METER LIGHT FAIL TO COME ON.

Procedure

Check:

1. Fuse - (main) 4. Lights switch

2. Battery 5. Dimmer switch

3. Main switch 6. Wiring connection (entire lighting system)

NOTE:

Remove the following parts before trouble shooting

1. Battery cover 3. Upper front panel 5. Seat and compartment 7. Rear panel

2. Front fairing 4. Handlebar panel 6. Handle 8. Side covers Use the following special tool in this troubleshooting section

Pocket tester: 90890 - 03112


5. Dimmer switch/Pass switch

Refer to "CHECKING SWITCHES"

section

6. Wiring connection

- Check the connection of the entire lighting system.

Refer to "WIRING DIAGRAM"

- Check the condition of each of the lighting system's circuits.

Refer to "LIGHTING SYSTEM CHECK"


NO CONTINUITY

Replace the left handlebar switch

POOR CONNECTIONS

Correct



1. Fuse

Refer to "CHECKING SWITCHES"

section.

CONTINUITY

2. Battery

- Check the battery condition

Refer to the "BATTERY INSPECTION" section in CHAPTER 3.

CORRECT

3. Main switch

Refer to "CHECKING SWITCHES"

section.


NO CONTINUITY

Replace the fuse

INCORRECT

- Clean battery terminals

- Recharge or replace battery

NO CONTINUITY

Replace the main switch


LIGHTING SYSTEM CHECK

1. If the headlight and the high beam indicator light fail to come on.

1. Bulb and bulb socket

Refer to "CHECKING SWITCHES"

section

CONTINUITY


NO CONTINUITY

Replace the bulb and/or bulb socket


2. Voltage
- Connect the pocket tester (DC20V) to the headlight and high beam indicator light couplers.
#A When the dimmer switch is on low beam #B When the dimmer switch is on high beam or the Pass switch is pushed.
Headlight: Tester (+) lead-(GreenØ or YellowØ lead Tester (-) lead-( BlackØ lead. High beam indicator light: Tester (+) lead-( Blue lead Tester (-) lead-( Black lead. +
NO CONTINUITY


4. Lights switch

Refer to "CHECKING SWITCHES"

section


NO CONTINUITY


CONTINUITY

+


Replace the right handlebar switch





© um.co.ua - учбові матеріали та реферати