загрузка...
загрузка...
На головну

IF THE IGNITION SYSTEM FAILS TO OPERATE. (NO SPARK OR INTERMITTENT SPARK)

  1. A Radio Communication System
  2. A SYSTEM OF POWER
  3. AIR BLEEDING (HYDRAULIC BRAKE SYSTEM)
  4. Amadeus Information System (AIS)
  5. An 1864 law overhauled Russia's judicial system, making the judiciary an independent branch of government for the first time.
  6. Ass. prof. Zhauticova S. B., Maxutova A. K."Pathophysiology of cardio-vascular system"// Educational-methodical manual// Karaganda, 2006.- 57.
  7. AUTO CHOKE AND CARBURETTOR HEATER SYSTEM

Procedure Check:

1. Spark plug 6. Main switch

2. Distance between spark plug electrodes 7. Feeding coil resistance

3. Spark plug cap resistance 8. Side stand switch

4. Ignition coil 9. Wiring connection (entire ignition system)

5. Pickup coil resistance

NOTE:

Remove the following parts before troubleshooting

1. Footrest board 3. Seat and compartment

2. Cowling body

-
3. Spark plug cap resistance
- Remove the spark plug cap. - Connect the pocket tester (Ω x 1 k) to the spark plug cap.   NOTE: - When removing the spark plug cap, do not pull the spark plug cap from the high tension cork - Remove, Turning counter-clockwise - Connect , Turning clockwise - Check the high-tension cord when connection the spark plug cap. - When connecting the spark plug cap, cut the high tension cord about 5 mm.
 
  Spark plug cap resistance: 10 kΩ(20ºC)
Use the special tools specified in the troubleshooting section


+

2. Ignition spark gap
- Disconnect the spark plug gap from the spark plug - Connect the ignition checker Ø as shown. Ø Spark plug - Turn the main switch to "ON" - Check the ignition spark gap §a . - Check the spark by pushing the starter switch, and increase the spark gap until a misfire occurs.
  Minimum spark gap: 6 mm (0.24 in)

OUT OF SPECIFICATION OR NO SPARK


MEETS SPECIFICATION

The ignition system is not faulty.

Tester (+) lead-(Spark plug sideØ Tester (-) lead-(

High tension cord sideØ



  Ignition checker: 90890 - 06754
Pocket tester: 90890 - 03112
1. Spark plug

- Check the spark plug condition

- Check the spark plug type

- Check the spark plug gap

Refer to "SPARK PLUG INSPECTION" section in CHAPTER 3.

Spark plug gap: 0.7 - 0.8 mm

+


Standard spark plug: CR8E/NGK

OUT OF SPECIFICATION

Repair or replace the spark plug.


CORRECT

+


OUT OF SPECIFICATION

Change the spark plug cap.





загрузка...
© um.co.ua - учбові матеріали та реферати