Головна |
************************************************************ Measurement and adjustment steps:
- Place the scooter on a level surface
- Place a hydraulic jack beneath the engine so that the carburettor is in a vertical position.
-- Connect the fuel level gauge Ø to the drainage tube Ø.
Fuel level gauge: 90890-01312
- Loosen the drain screw Ø.
- Hold the gauge vertically up to the tank.
- Measure the fuel level (a) with the gauge.
- If the level is incorrect, adjust.
- Remove the carburettor.
- Inspect the valve seat and the needle valve.
- If both are worn, replace.
- If both are in order, adjust the height, doubling the floater pin .
- Check the height again.
************************************************************
AUTOMATIC STARTER INSPECTION
(Ambient temperature below 45ºC)
1. Remove:
- Carburettor
2. Inspect:
- Auto choke assembly
Connect a tube of 5mm-diameter Ø to the choke
Ø, and blow through it. Possible, In good condition
Impossible, Replace auto choke unit.
3. Inspect:
- Auto choke assembly (with battery)
************************************************************ Inspection and adjustment steps:
- Connect the auto choke unit leads to the 12V battery for 5 minutes.
Black terminal -(12 V battery (-) Ø
Red terminal -(12V battery (+) Ø
Connect a 5mm-tube to the starter Ø and blow with the mouth.
Possible, Replace auto choke unit. Impossible, Good condition.
************************************************************